Quote:
Originally posted by Brian_C6
45:1 and 50:1 is so close it shouldn't matter. I would mix 45:1 and use that mix in the 50:1 motor.
50:1 and 32:1.... that is a big gap and you run the risk of blowing the engine. If you absolutely HAD to use the same mix, you are better off using too much oil, than too little. Extra oil woul basically cause the motor to run rich and the worse (short term case) would be possibly fouling a plug. Not enough oil would cause improper lubrication and build up friction... causing over heating and eventually blow.
Brian |
tanks, mang-- just the kinda answer I was looking for.
(assuming, of course, that you didn't just make it up to blow smoke up my ass...
)