Quote:
Originally Posted by JunoAF  not sure if this helps or if you're past it but ive known guys that have replaced those screws with allen head screws. seemed to help out a LOT. |
Good point.
Greenmonster - I didn't see your other posts after mine. You can often use a non-JIS screwdriver as long as you're careful. It can help to heat the bolt as well as give it a couple of taps w/ a hammer (use hammer to tap the screwdriver into the head). Using an open flame for heat will be interesting on carbs...
Can use a heat gun or soldering gun in this case.
If you still need to break down carbs, I have a can of nearly new Carb Dip you're welcome to have.
[edit] And no, I don't know where I would buy JIS screwdrivers locally. Surprisingly enough I actually don't own any...just never seem to get around to buying a good set. Online is your best bet.