0
ive got a 1994 wrangler project that ive been too busy and broke to finish, plus i got a motorcycle so my focus has kinda changed. ideally i sell this and buy a stock wrangler to dd and wheel with 33's. i know this is a motorcycle forum, but maybe someone knows someone looking for a project like this.
4.0 with intake, tb spacer, brown dog 1" motor mounts and red top optima
AX-15 with B&M short shifter and poly mount
231/300 doubler twin sticked
full width front 44, lp, 4.10's, hi-steer, beefy homemade diff cover
full width rear 14 bolt, welded, traction bar, 4.10's, ruffstuff 3/8" diff cover
tom woods dual cardan rear shaft
recentered hummer h1 8 bolt double beadlocks, 8 lug (stazworks hdpe inserts and centers, my welder burned them in)
homebuilt highline front fenders
hard doors
soft top
very little rust
solid frame
SOA with xj rears and custom toyota/yj fronts for a combined 107" wheelbase
new alternator, coil, and crank sensor
14" travel bilstein 5125 front shocks
e350 mc
daystar poly 1" bodylift
raised factory fuel tank
pioneer cd player and polk audio speakers
mile marker 9000lb with cover and roller fairlead
gc 136 amp alternator
chevy astro steering box
jk flares coming my way soon...
its not without problems
*it wont turn over. i replaced the alternator with a 136 amp gc unit when the old one was seized, from that point it wouldnt turn over. cranks away, but its got no spark, fiddling with it one day i broke off one of the dist cap bolts...pima
*rear yoke on the rear shaft is the wrong size, was going to run a 60 with a 1350 yoke and now its got a 14 bolt in it, i can never make up my mind...
*drivers floor rotted
*winch controller got caught in the drum and fried the wires to the solenoids, not sure what else may be wrong
to finish:
make it run
replace rear ds yoke or axle yoke
front driveshaft
brakes need attention and flex lines
rear shocks
shock mounts all around
seal gas tank from cab
relocate brake lights
1 bad rear bodymount
install front shackles
mount cable shifter
relocate exhaust
axle vent lines
grade 8 bolts for rear spring
bumpstops
id like to sell it whole for $3000, i would trade it for a stock 4.0 5 speed wrangler.
build thread here
http://www.toyotacrawlers.com/forum/...p?topic=3070.0
pics here
http://s99.photobucket.com/albums/l286/gus310/my%20yj/