0
Long story short, I need to gather thousands for some medical bills and I'm not selling the yz so I am putting this up for sale to see if I get anything for it .
07 CRF450R- In supermoto/road race trim (offroad only title). I do not have the stock wheels to sell it as a dirtbike but have basically everything else and a million extras. Bike was raced at LRRS in 09, one friday practice and one half trackday, that is it. Engine and trans. oil were changed every time the bike was ridden. Valves were checked before last race weekend of 09 and all valves are .001" off except for one exhaust valve that was .002" off. All safety wired/race ready.
Wheels- 17" 3.5" front/5" rear BEHR rims/RAD hubs
UFO white plastics set/custom 2FS graphics on bike
Brakes- Braking supermoto system front 16mm master/caliper, Braking wave rotors front and rear, Goodridge steel braided line front/steel braided on rear as well
TriStar 10mm offset triple clamps, black/lots of adjustment (new steerer bearings top/bottom this year)
Factory Connection revalved suspension (setup for mx, I just upped the compression clickers), Stiffer rear spring (have stock spring as well)
Factory Connection team rear linkage ($400)
Factory Connection shock preload adjuster (over $100) runs on needle bearings
Light Speed carbon fiber engine guards left/right
Works Connection radiator braces
Sunline quick adjust fuel screw
Turner billet alum. engine plugs
Turner Billet alum. hot start carb connector (replaces stock plastic part that can often jam/crack)
Hinson clutch components (basket/pressure plate...)
15/39 gearing Sunline sprockets and brand new red EK mrd6 chain
sdg step seat
Sunline alum. case guard shaved down to fit the 15t sprocket.
Filtron billet oil filter cover and Filtron stainless oil filters used (rotate between 2)
Sunline full wrap handguards
Sunline billet alum. throttle tube
Sunline alum. shift lever
SME catch can setup
SME axle sliders front and rear (rear are axle blocks/sliders)
Tires- Has rain tires mounted currently with like 5 laps on them (over $400). Will also include take off Pirelli slicks that I was going to mount back on for dry weather (2 sets of slicks so 6 tires total).
Extras:
E-line carbon fiber skidplate (lost mounting hardware for it but simple alum. brackets could be made to mount it)
TwinAir airbox cover (for cleaning)
Stock front brake setup (full system ready to bolt on)
stock carb parts
stock throttle
axle blocks
stock oil filter cover
stock linkage
stock rear spring
brand new set of black plastics (fenders/front plate and shrouds with built in air scoops)
(2) red front fenders
(2) red rear fenders
red stock shrouds
stock Honda seat
Gasket sets for whole engine
extra Honda bolts/o rings
Stock shifter
stock case guard
5-6 air filters
extra Filtron stainless oil filter
all I can think of right now
$5200