0
Alright...I'm pretty frustrated with this rebuild...it's been a nightmare.
02 CR125 engine rebuild....went with Wiseco lower-end kit and upper stock piston kit. Got the engine back together and in the frame, but I can't get ti to turn over.
Things I've tried...new spark plug, tightening the the spark plug boot, I get a spark when grounding the plug to the head. I can smell gas in the cylinder, I cleaned the carb and peckock valve, pulled the fuel line and gas comes out when the valve is on. Used a meter on the wiring, seems good, even disconnected the shut-off switch to eliminate it. Seems to have pressure when I kick it over, but not getting a reading on the pressure tester at all. I never checked the gap on the new piston ring before I installed it, so was wondering if that might be it. Or the exhaust valve?