Weld work

[slammp]

I have a pin style front stand by T-Rex that I purchased for my RC51. My Brutale has a pinless triple. I am looking for someone who can weld me up a piece to fit over the pin top (like a sleeve) with has a flat plate on top and a lip at either end (front and back) to hold the bike up by the triple.

I can lift it by the forks with my current stand but I foresee pulling my front wheel this winter and would like the added functionality.

Anybody able or know someone (preferably near Boston) who could do this?

[Jim]

tricky?

[slammp]

I was thinking about Mike, but Chelmsford is a little bit of a hike from me and I would probably need to go twice once to drop of and once to pick up.

[DucDave]

I was thinking about Mike, but Chelmsford is a little bit of a hike from me and I would probably need to go twice once to drop of and once to pick up.

...he comutes to boston every day...

[slammp]

very good point by you. I forgot that.

[KB]

I would try to get a few guys and just lift it up each time.

KB

[slammp]

I would try to get a few guys and just lift it up each time.

Can they hang around all winter stationary while I tinker at it.

[KB]

Can they hang around all winter stationary while I tinker at it.

Fuck yeah!!

KB