why would 1 carb. read higher vacum???

[wastedincome420]

Why would 1 carb. read much higher then the other 3 carbs on a "carb sync" tool????
I have out on the adjuster to the point it fell out, BUT it STILL reads much higher then all the others ????
PLease help!!!!!!!!!!!!!!!!!

[R7]

vacume leak?

[need4speed]

pinched or kinked vacuum line

[PinHead]

Low compression ?

[RandyO]

not many vacuum lines... and logic tells me it's unlikely a vacuum leak, more likely a plugged vacuum line... maybe a passage inside the carb

[R7]

doesn't have to be a vacume line cracked intake boot, loose clamp, cracked o-ring in air/fuel screw, bad seal in the carb tool itself... there are tons of places air can leak in

[RandyO]

problem fixed... discovered slightly tweaked adjuster screw bracket

[TLRMan]

It would read LOWER if you had a vacuum leak.....
Higher means throttle plate/slide is closed more than the others

[SV1KScott]

Well that just sucks

I thought I would come out of hiding.

[beet]

[SV1KScott]

It's a fun ride.
5 page spread in August Cycle World about it, "Forgotten Twin"
I hate it with the lower fairing, looks like a new dress on the old whore and it's heavier and slower with it. Go figure.