0
Well, not sure if its a problem bleeding them or what. Anyway, my bike fell over on its right side, and the end of the brake lever broke off. The way the lever broke was while compressing the brake lever (like pulling the lever in). After i picked the bike up, the brakes were soft, but pumped up in a couple pulls. But, as soon as you move the bike (just enough for the pads to be pushed back in) the brakes go soft again. I tried bleeding them again, but same thing. Took the master cylinder apart thinking something in there was bad, but it looked fine. Its not like an air bubble, once you pump the brakes up it holds until you move the bike, the lever will stay hard over night, but as soon as you roll the bike it goes back to the grip.
Any ideas? Did i do something to one of the calipers?
(Oh, and the brake setup is from a 00' tl1000r if that matters)
Thanks