clip-on angle

[breakdirt916]

how do I get the clip-on angle to match what came from the factory?

just line it up the best you can, and run it?

I replaced one clip on, and it just doesn't look straight...and since the upper fairing stay is bent c/o the grass in 12a, I can't tell what to line up the bars to

[Pigman]

From the Fast guys Not me......they are better off pushed out almost Square. Allows you to get off the bike more and Hang. I was close to stock and was cramped up and pushed them out and its DEF bettrer... My2 cents

[golden chicken]

I would get a square and measure using the triple as a reference....maybe make some alignment marks on the upper triple?

[DaveZX6r]

Turn the wheel to full lock and line it up with your tank. You can use a ruler or tape measure if you want to be anal about it. Thats what I used to do with my fzr.

[OreoGaborio]

I adjust them roughly to where I want them to be, then go full lock right, full lock left and see if they're symmetrical & clear everything.

[BLACK SQUIRREL]

I set them until they feel Right

[tropicoz]

That's pretty much what I did. I set them to the OEM position, then gradually moved out during a days ride until it felt right. Much wider out compared to stock.