0
I know you can put it in the gas tank but if you want immediate results they recommend another way.
I was on seafoams website reading over the instuctions on how to use it. Now I know my basics of a bike engine but the things they described I'm not too sure on.
Here's seafoams instructions:
With engine warm, slowly pour 1/3 to 1/2 pint through carburetor or throttle body throat. (If vehicle is port injected slowly pour SEA FOAM through direct manifold vacuum line that will feed all cylinders, possible sources are P.C.V. valve or brake booster line.) This will pull SEA FOAM down on top of the pistons and to the back of the intake valves to dissolve carbon. Turn ignition off. Restart engine after 5 minutes. If severe carbon build up is apparent, use more Sea Foam as previously directed. Make sure exhaust is well ventilated when using Sea Foam in these various ways as fumes will be extreme for a short time.
Now here are my questions:
1) It says to pour through carb or throttle body throat. Where exactily do I pour it into the carb??? The only thing that is open that you can pour it into is the velocity stack on top of the carb (with tank off). Is that where they want me to pour it into?
2) Where is the throttle body throat located?
3) What do they mean by port injected? Fuel injected?