0
Today i put on a new chain and front sprocket on one of my bikes. and when i pull the clutch in, its EXTREMLY difficult to spin the rear wheel. In neutral its fine. I even went as far as removing the rear caliper and loosening the rear axle nut (and i didnt go superman on it either) just to eliminate those definitely.
i pulled the clutch basket out and every single friction and steel plate is reallly sticky. doesnt have the coated in oil feel. more like a glue. with all the disks out it rotates just fine in gear. put a few in, same thing, once i get about halfway it starts tensing up. it pretty much locks up once i get the Pressure? plate on. Ive adjusted the clutch cable so that it was definitely pulling the clutch out and yet no change.
If it matters my shop hasnt been heated this winter and im using Rotella 15w40 for oil