ANTIQUES - $600
ANTIQUE / VINTAGE MONSON MAINE SLATE SINK
This is a vintage slate sink manufactured by the Monson Maine Slate Co. Boston, MA. It measures 36 inches wide by 8 inches deep by 22 inches front to back. The back is 20 inches high. It’s a single basin with one drain. It also has a built-in soap dish with drain holes. I contacted the president of the company for some help to date it and she estimated that it was from the early 1900’s so it’s approximately 100 years old. I can forward you the email if you would like. It’s in good condition but it needs to be cleaned.
BOATS - $300
1955 BRASS ROSS BCF HEAT EXCHANGER / OIL COOLER
This is a heat exchanger / oil cooler that came off a large diesel boat engine. It was manufactured by Ross Heater & Manufacturing Co., Inc. Buffalo, NY. The manufactured date on the plate is September 1955. The part number is 7M802A9. It is made of brass aside from the pipe fittings. It needs to be cleaned up and the fittings should probably be replaced before use.
CARS+TRUCKS - $250
6 FOOT TRUCK CAP FROM A CHEVROLET S10
This is a 6 foot truck bed cap from a 91 Chevy S10. It’s in good condition. The side and back windows are tinted. The side windows slide open. The rear window and latches work fine. There is a brake light and a dome light in the back. It’s in good condition.
TOOLS - $300
VINTAGE 65 LB BLACKSMITH ANVIL WITH WOODEN BLOCK STAND
This is an old blacksmith’s anvil. It measures 2 feet across the top. It’s mounted on a block of wood that is a little rotten on the bottom. It weighs approximately 65 lbs but the scale is old so it may be off. It’s been stored inside so it’s in good condition.
BOATS - $75
VINTAGE 1952 - 1954 3HP EVINRUDE LIGHTWIN OUTBOARD
This is a twin cylinder 3hp Evinrude Lightwin outboard motor. It’s been stored inside but it hasn’t been started in 15-20 years. It has compression. Everything is intact but it will need to be gone through.
service manuals and parts can be purchased here…
CARS+TRUCKS - $300
HOME MADE WOOD TRAILER WITH SUSPENSION 7 FEET LONG X 4 FEET WIDE X 2 FEET HIGH
This is a home made wooden trailer which measures 7’ X 4’ X 2’ . It’s been covered so it’s in good condition. The hitch has been painted and is included as well as the board for the back. It isn’t wired for lights but it wouldn’t be a hard job. The tires are in good shape.
CARS+TRUCKS - $175
HOME MADE WOOD TRAILER WITH SUSPENSION 8 FEET LONG X 3.5 FEET WIDE X 3 FEET HIGH
This is a home made wooden trailer which measures 8’ X 3.5’ X 3’ . It’s been covered so it’s in good condition. The hitch has been painted and is included as well as the board for the back. It isn’t wired for lights but it wouldn’t be a hard job. The tires which are included are in good shape and have been kept inside.