0
I want to make a small flat bracket to mount a RAM mount or Go Pro on a Ducati Supersport, using 3/16" sheet aluminum. The finished piece is about 3 1/4" x 3 1/4, with two holes drilled to 3/8" D.
This will attach to the two chicago screws attaching the plastic housing around the ignition.
A crude mock-up using hardboard is shown to illustrate the cutting needed. The critical dimensions and cuts are hole locations and the ears around the holes to avoid the housing.
Any suggestions where to get this done? (I am in metrowest area, but some travel is OK too.)