ISO 5 lug hub with 100 mm bolt circle

[stoinkythepig]

Anyone have an old 100mm 5 lug hub kicking around? I need one for a cheap bastard project. It must have a hollow center like you'd find on a FWD front hub. I don't care about the condition of the bearings (I'm hoping for one that's been swapped out due to bad bearings). I only need the hub and lugs to be intact. 5x100mm is a very common size on Toyota, Subaru, GM, Chrysler, Saab and VW cars.

Here's a list of cars that use this bolt pattern: http://www.roadkillcustoms.com/hot-r...#axzz34o3ayE00

[carsick]

I must have one, just need to look through the pile. PM me if I forget to reply.

[myzx6]

I just pulled a wheel bearing hub assembly off an 09 g6 which I'm pretty sure is 5x100, if not I have a a few more I haven't scrapped yet. I can press it out , not sure how far north you are but if not far from mass I can deliver either after work this week or weekend, if your way up north I can meet you half way or ship. If no one closer has one

[stoinkythepig]

I just pulled a wheel bearing hub assembly off an 09 g6 which I'm pretty sure is 5x100, if not I have a a few more I haven't scrapped yet. I can press it out , not sure how far north you are but if not far from mass I can deliver either after work this week or weekend, if your way up north I can meet you half way or ship. If no one closer has one

The G6 uses a 5 x 110, so it won't work for me, but if you have a 5 x100 and are headed up this way at some point, I am in Raymond, it's in southern NH, half way between the beach and Manchester. I also have an office in Westford, MA that I visit a few times a month. I'd be happy to meet somewhere or drive to Southbridge.

[myzx6]

I'm a mechanic so I have no shortage of hubs laying around, ill look through my scrap pile this mornin

[stoinkythepig]

Thanks

[Pigman]

I am in Northboro for work all week and can bring it up to Pembroke for pick up if needed...................just pm me