Safety wiring

[Jim]

Pro Bolt sells a pre-drilled pad pin set. got them for my street and track bike

[xsiliconkid]

Turn 11 hurts when your brake pad falls out ... trust me.

you are lucky - a few years back we had a death due to pins falling out....

[xsiliconkid]

Me to, No tape involved

I would still carefully check the bleed hole in the Brake res cover - might/may be blocked.....
of course you can simply overfill (add fluid with worn pads, then replace after pushing back in the pistons without removing excess fluid

[xsiliconkid]

Pro Bolt sells a pre-drilled pad pin set. got them for my street and track bike

nice, are they case hardened?
just checked, they are just stainless. i would be checking for wear/gouge marks on pins.....that would not be nice....

[Jim]

nice, are they case hardened?

not sure the difference. all i know is they sell them in SS and Ti

[xsiliconkid]

you don't want gouge marks on pins from the constant vibration of pads - - the pads need to slide freely - case hardened is very tough...

[BLACK SQUIRREL]

I would still carefully check the bleed hole in the Brake res cover - might/may be blocked.....
of course you can simply overfill (add fluid with worn pads, then replace after pushing back in the pistons without removing excess fluid

I went 1 better and Tossed the whole Magura/ Brembo Setup in the Trash. Went back to OEM Calper and Nissen Master