0
Motor is a basket case, although, a really nice basket case.
I don't have a 600RR anymore and I really need the space in the shop
Free to a good home.
The good and the bad:
It bent the crank and ate a big end rod bearing. Tiny bit of valve contact on one cylinder, but valves might be OK Otherwise it's a solid starting point if you're looking for a project:
2MM overbore JE pistons
Carillo rods (one shows heat marks, prob junk)
ported/skimmed head
undercut trans
full cryo treat on the whole motor
Some HRC stuff: adjustable cams, valve springs, clutch springs, electrode-less sparkies...
It's disassembled, but bagged, wrapped and complete.