05 CBR 600RR motor

[Tricky Mike]

Motor is a basket case, although, a really nice basket case.
I don't have a 600RR anymore and I really need the space in the shop
Free to a good home.

The good and the bad:

It bent the crank and ate a big end rod bearing. Tiny bit of valve contact on one cylinder, but valves might be OK Otherwise it's a solid starting point if you're looking for a project:
2MM overbore JE pistons
Carillo rods (one shows heat marks, prob junk)
ported/skimmed head
undercut trans
full cryo treat on the whole motor
Some HRC stuff: adjustable cams, valve springs, clutch springs, electrode-less sparkies...

It's disassembled, but bagged, wrapped and complete.

[PhilB]

Is it sheer coincidence that this is near the thread on 600cc bumper cars?

PhilB

[Tricky Mike]

Is it sheer coincidence that this is near the thread on 600cc bumper cars?

PhilB

Not entirely. Maybe I should make the new owner sign a waiver?

[Philkinson]

I mean, I shouldn't... But I'll bite. Where ya located at Mike? Anywhere between Providence, Ri and Loudon?

Sent from my SM-G920T using Tapatalk

[Tricky Mike]

That's the spirit. Yeah, I'm on the mean streets of Chelmsford, MA.
I'm catching a 2:00 flight this afternoon, though. I'll be here this morning, otherwise I'll be back on Thursday.

[Philkinson]

Oh boy, it's meant to be... I'll be passing through next Saturday around noon with an empty car. I'll pm you and try to figure out the details

Sent from my SM-G920T using Tapatalk

[Tricky Mike]

Sounds good. Pardon any response lag... I'll be traveling.

[Philkinson]

Welp, does anyone want this?
Cbr is long gone, Tricky Mikes parts have been in my basement for too long now. Can't bring myself to scrap all of these goodies.
FREE in Coventry RI

[OreoGaborio]

Make a cool little side table out of it