gearing

[SVRACER01]

anyone know of a gearing chart that i can use to figure out what to run at NJ? maybe even one with speed ratings. after reading Mikes review and saying he was doing 125 in some corners im thinking maybe +2/-5 (17/39) might be more appropriate.

[Doc]

Gearing Commander: Motorcycle Gearing Ratio Sprocket RPM Speed Chain Calculator

[SVRACER01]

cool i already ordered a 15/40 setup and that should work :fingerscrossed:

[pasta-rocket]

I rode with loudon gearing and it was fine. If you wanted to maybe a couple teeth.

[BLACK SQUIRREL]

cool i already ordered a 15/40 setup and that should work :fingerscrossed:

Any chance I can borrow that 40 for daytona

[SVRACER01]

prolly. you goin to NJ?

PS...its a 520

[BLACK SQUIRREL]

prolly. you goin to NJ?

PS...its a 520

No But My Bike and Gear are going as Part of the DAYTONA TRAIN. You can give the sproket to GINO And I will make sure it comes back to you. I am Also bringing an Extra cush drive To make gearing changes easier. If you want to use it. I also have a 42 Tooth. if you want to try that.

Yes all 520

[SVRACER01]

sounds good

[OreoGaborio]

Anyone got any spare 2nd gen SV gears? I haven't decided if I'm taking the SV or the Tuono to NJ... probably the SV.... if so I'll probably wanna drop a couple teeth in the back, too.

[BLACK SQUIRREL]

Anyone got any spare 2nd gen SV gears? I haven't decided if I'm taking the SV or the Tuono to NJ... probably the SV.... if so I'll probably wanna drop a couple teeth in the back, too.

According to Vortex the Sprokets are the same for 1st and 2nd GEn

[daviid]

i ran 15/46 and it was fine.

[SVRACER01]

yeah but youre only faster than a snail

[SVRACER01]

im starting to think dropping the front may be too much so i may go back to the 14 if i find it chugging

[brewmaster]

I'm going to run either a 15/39 or a 16/41 on the SS. Preferably the 16/41 so I can leave the rear set up the same as Loudon.

[daviid]

yeah but youre only faster than a snail

this i do not deny.