i hate honda

[Tricky Mike]

I priced one at just over 20 grand.

For the Prototrak setup alone? Yikes. I had casually looked at their retrofit 3-axis... Just daydreaming. didn't actually price it, though. In any event, that would be way down the line... I still don't have a lathe.

[TLRMan]

For the Prototrak setup alone? Yikes. I had casually looked at their retrofit 3-axis... Just daydreaming. didn't actually price it, though. In any event, that would be way down the line... I still don't have a lathe.

It includes the bridgeport too!
Been a couple years, but they are the best bang for the buck!
If you have Cad/Cam software, chances are they have a post processor (fanuc generic) that'll support it. I know mastercam does...

[Rye]

Kham, I have one already made for my XR. I think it's 1 1/8. I cut it as a swingarm nut remover to access bearings for lube and may line right up with the F4i as they're both Honda. I may be up your way Sunday. 1/2 inch drive, btw.